Click here for manuals/cutsheets.
Model "SL3000ULDM"

Dual Motor Commercial Slide Gate Operator for use in high temperature environments. One motor opens the gate, the other closes it.

120 VAC Power -  built-in 120 VAC power receptacle (NEMA 5-15).

Alarm -  If the gate hits an object twice while opening or closing, the system will shut down and an alarm will sound for five minutes.

Alternate Outputs  - With Omni Option board, three push button command control, buglar alarm input and output.

Burglar Alarm -  With Omni Option board, interfaces with existing home alarm or alarm output.

Digital Motor Protection -  Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops.

Electronic Inputs - Radio receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station.

ERD Sensor -  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.

Gate Traveling Time -  Adjusted by a precision mechanical device and electrical limit switch system.

Integrated Loop Detectors -  Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop.

Intelligent Master/Second -  Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology.

Magnetic Lock -  With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate.

Modular Board -  Uses LEDs to indicate all input and output functions of the gate operator.

Motor Drive -  Solid state electronic motor drive system is incorporated into the board.

Power Input -  Controls power input to the board with convenient switch.

Power Management -  Board includes electronic power management with over curent shutdown and automatic recovery.

Soft Stop -  Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy.

Spike Suppressors -  20,000 Amps and near lightning protection with modular omni surge suppressor. Initial response time: 0.000000000001 seconds.

Three Push Button Control -  On board gate operator control for close, stop and open.

Timer -  Adjustable timer can be set from 0-60 seconds.

Approval -  UL and ETL listed to the latest UL325 and UL991 specifications.

Chassis -  Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal.

Cover -  High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance.

Cycles -  Capable of continuous cycles daily.

Dimensions -  Length = 18in x Width = 19in x Height = 25in

Emergency Release -  The gate is easily disconnected by turning the release handle. the best option is our DC-1000CSW.

Finish -  All metal parts are gold zinc plated for rust proof protection.

Gate Length -  37 feet maximum gate length.

Motor -  Equipped with two 1/2 hp parking gate motors. One motor opens the gate, the other one closes it.

Output Shaft -  1 inch cold rolled steel.

Shipping Weight -  157 pounds.

Travel Speed  - 12 inches per second average gate speed.

Weight -  139 pounds.

Weight Capacity -  800 pounds maximum gate weight.

Worm Gear Reduction -  30-to-1 worm gear reduction in an oil bath.