Commercial Swing Gate Operator with two 1/2 hp motors that work in conjunction giving this machine 1hp for use on heavy gates.

Alarm  - If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.

Alternate Outputs -  With Omni Option board, three push button command control, buglar alarm input and output.

Burglar Alarm  - With Omni Option board, interfaces with existing home alarm or alarm output.

Digital Motor Protection -  Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops.

Electronic Inputs -  Radio receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station.

ERD Sensor -  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.

Gate Traveling Time -  Adjusted by a precision mechanical device and electrical limit switch system.

Integrated Loop Detectors -  Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop.

Intelligent Master/Second -  Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology.

Magnetic Lock -  With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate.

Modular Board -  Uses LEDs to indicate all input and output functions of the gate operator.

Motor Drive -  Solid state electronic motor drive system is incorporated into the board.

Power Input - Controls power input to the board with convenient switch.

Power Management -  Board includes electronic power management with over curent shutdown and automatic recovery.

Soft Stop -  Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy.

Spike Suppressors - Fast response time (50 nanoseconds) when subject to an impulse surge (lightning strike) up to 100 amps.

Three Push Button Control -  On board gate operator control for close, stop and open.

Timer -  Adjustable timer can be set from 0-60 seconds.

Approval  - UL and ETL listed to the latest UL325 and UL991 specifications.

Chassis -  Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal.

Cover -  High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance.

Cycles -  Capable of 60 cycles per hour.

Dimensions -  Length = 24.5in x Width = 15in x Height = 285in

Emergency Release -  Can be easily disconnected ty turning the emergency handle 180°.

Finish -  All metal parts are gold zinc plated for rust proof protection.

Gate Length -  20 foot gate length, max.

Motor -  Equipped with two 4.7 AMP, 115VAC, 1/2hp instant reversing motors that work together, equalling 1hp.

Output Shaft  - 2.5 inch cold rolled steel.

Shipping Weight  - 199 pounds.

Swing Arm -  Non-scissor type arm action.

Travel Speed -  90° opening in 13-15 seconds.

Weight Capacity -  1000 pounds.

Worm Gear Reduction  - Two, 30-to-1 worm gears equal a 900-to-1 reduction. Both are lubricated in an oil bath.