Commercial Swing Gate operator for use in high traffic applications,our most popular swing gate operator.

Alarm - If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.

Alternate Outputs -  With Omni Option board, three push button command control, buglar alarm input and output.

Burglar Alarm - With Omni Option board, interfaces with existing home alarm or alarm output.

Digital Motor Protection -  Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops.

Electronic Inputs -  Radio receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station.

ERD Sensor -  If the gate hits a vehicle while closing it re-opens. If it hits a vehicle while opening it stops, reverses 4 to 6 inches and stops again.

Gate Traveling Time - Adjusted by a precision mechanical device and electrical limit switch system.

Integrated Loop Detectors - Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop.

Intelligent Master/Second - Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology.

Magnetic Lock - With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate.

Modular Board -  Uses LEDs to indicate all input and output functions of the gate operator.

Motor Drive -  Solid state electronic motor drive system is incorporated into the board.

Power Input -  Controls power input to the board with convenient switch.

Power Management -  Board includes electronic power management with over curent shutdown and automatic recovery.

Spike Suppressors -  20,000 Amps and near lightning protection with modular omni surge suppressor. Initial response time: 0.000000000001 seconds.

Three Push Button Control -  On board gate operator control for close, stop and open.

Timer -  Adjustable timer can be set from 0-60 seconds.

Approval - UL and ETL listed to the latest UL325 and UL991 specifications.

Chassis - Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal.

Cover - High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance.

Cycles - 75 cycles per hour with a 600 pound gate.

Dimensions -  Length = 20.5in x Width = 15in x Height 28in.

Emergency Release - The gate is easily disconnected by turning the release handle. the best option is our DC-1000CSW.

Finish - All metal parts are gold zinc plated for rust proof protection.

Gate Length  - 18 feet maximum gate length.

Motor - 1/2 hp, instant reversing, 120VAC, 4 amp, 1625 rpm, with high speed ball bearings.

Output Shaft -  2.5 inch cold rolled steel.

Shipping Weight  - 175 lbs.

Travel Speed -  90° opening in 13-15 seconds.

Weight  - 160 pounds.

Weight Capacity - 600 pounds maximum gate weight.

Worm Gear Reduction - Two, 30-to-1 worm gears equal a 900-to-1 reduction. Both are lubricated in an oil bath.